Qolsys Keyfob—Battery Replacement

Find the image of your keyfob below to view instructions on how to complete your battery replacement. Due to the versatility of your panel, only commonly paired keyfobs are shown. If your specific keyfob is unlisted, you can search for other keyfobs here. If you need further assistance, you can text a Support Representative any time at 469.513.8685.

Once you've replaced the batteries, the error on your panel should clear within one hour. If you would like to clear the error manually, click here.

Qolsys QS1310-PO1 IQ FOB 4-Button Keyfob:

Remove the screw from the back of the keyfob to remove the back panel.

Remove and replace GF27A 12-Volt Alkaline battery.

______________________________________________________________________________

Qolsys QS1331-840 IQ FOB-S Encrypted 4-Button Keyfob:

Insert a coin into the side slot to pry the circuit board from the backplate.

Remove and replace CR2032 battery with the + side face down.

______________________________________________________________________________

Qolsys QS1312-P01 DESK IQ FOB 2-Button Keyfob:

Insert a screwdriver into the slot to open the front cover.

Slide the CR2032 battery out to remove and replace with the + side face up.

______________________________________________________________________________

Interlogix WST-102 Wireless Sensor 4-Button, 345Mhz, Chrome-Plated Keyfob:

With a key or small screwdriver, push up on the black tab located at the bottom of the keyfob and slide the chrome trim off.

Carefully separate the front and back piece of plastic to reveal the battery.
Remove and replace CR2032 battery with the + side face up.

Reassemble the plastic pieces, ensuring they click back together.
Ensure the notch in the chrome trim is aligned with the back of the plastic.